Skyhunter Boom Hinge

This is a boom hinge for the full-size Skyhunter. This design was inspired by Moggiex's design (https://www.thingiverse.com/thing:3109092); however, I wanted the hinge to fit over the booms and I wanted it to be easy to fold/unfold without the use of any tools.

For each side, print a pivot pin, a locking pin, and two of the hinges (rotate one of the hinges 180 degrees to fit into the other one). The pivot pin is held in place with a little CA. I purchased two small hairpin cotter pins from Home Depot to hold the locking pins in place. The hinges are held to the boom with small screws.

**I printed it standing up on the end away from the hinge, using a brim to keep it in place during printing.