Skyrim Guards Cosplay

I modified the cuts to make it easier and fit on the Ender 3. The size turned out good since it’s not too tall and I’m not Nordic, but if you have a very large head you don’t need to change anything, and if you have a very small head, you can just add some foam inside.

I used a 1 mm nozzle with one wall thickness and 10% cubic infill, with a 0.4 mm layer height to make it faster to print. The head took 6 hours, the face took 5 hours, and the side parts took 1 hour each, The tip of the head was printed in vase mode.