Thingiverse
Skysolve/Cedar Integrated Case
door Fabio_Eng
6
Downloads
10
Likes
0
Makes
Case for the plate solving electronic wiewfinders based on RaspberryPi :
Skysolve https://github.com/githubdoe/skysolve/
Cedar https://github.com/smroid/cedar-server/
Base body is available for Skysolve (with home/field switch) or Cedar (no switch)
Cover can be printed as a single unit (Cover_Full.stl) or it can be printed separately (CoverA.stl + CoverB.stl) and then glued together.
The camera Tilt plate fits the Innomaker IMX296 BW camera module
SD_Cover and Cap are meant to respectively close the SD card slit and to protect the camera lens during stroage: both are totally optional.
WARNING 1: To avoid damaging your PI Board, carefully check the fitting and especially the length of M4 screws connecting the dovetail to the main body BEFORE THE FINAL ASSEMBLY (i.e. without PI board in the case). Excessively long M4 countersunk screws may protrude and damage the Raspberry Pi board, so pay attention!
WARNING 2: Remove the pins for Trigger and Strobe from the camera. T
Skysolve https://github.com/githubdoe/skysolve/
Cedar https://github.com/smroid/cedar-server/
Base body is available for Skysolve (with home/field switch) or Cedar (no switch)
Cover can be printed as a single unit (Cover_Full.stl) or it can be printed separately (CoverA.stl + CoverB.stl) and then glued together.
The camera Tilt plate fits the Innomaker IMX296 BW camera module
SD_Cover and Cap are meant to respectively close the SD card slit and to protect the camera lens during stroage: both are totally optional.
WARNING 1: To avoid damaging your PI Board, carefully check the fitting and especially the length of M4 screws connecting the dovetail to the main body BEFORE THE FINAL ASSEMBLY (i.e. without PI board in the case). Excessively long M4 countersunk screws may protrude and damage the Raspberry Pi board, so pay attention!
WARNING 2: Remove the pins for Trigger and Strobe from the camera. T
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
