Skywalker Roaster External Electronics Enclosure

This is an electronics enclosure designed for moving the electronics outside the roaster.
Lid was held on with four zip ties.
Wires were fed through the hole where the mains power cable originally went through.

This was made for a 40x10 fan on the top 24VDC power supply and 40x20 fan on the bottom logic PCA.

There are also mounting holes for and Ardruino Nano (for Artisan support).

Required modifications:
1) One of the connector wires were a bit short, so it needed to be lengthened to reach the PCA.
2) If installing the Arduino Nano, either a) hardwire the USB connections or b) cut the bottom left corner off the lid to plug in the USB cable