Thingiverse
SL1 Platform Holder
por michealdon
9
Descargas
3
Likes
2
Makes
I have designed a build platform holder for the SL1 because I am lazy.
It works with low to mid sized models - taller models will still need the caveman approach of holding it in place order the vat or wasting a lot of resin.
The original model was a single object but supports killed the look of the model. I divided it into 2 models and have placed a notch on one point of the platform holder that needs to the facing the closed back of the machine fitting.
Recommend a good strong glue and allow plenty of time to set/cure
Design in Tinkercad as my license for Fusion 360 had lapsed.
I printed in both PLA and resin - Here are the details
PLA
0.15 Speed profile
20% in fill
12.79 meters of filament
Just over 3 hours to print.
RESIN
0.05
1119 layers
55ml resin used
PRUSA GREY TOUGH
4 hours 36 minutes
It works with low to mid sized models - taller models will still need the caveman approach of holding it in place order the vat or wasting a lot of resin.
The original model was a single object but supports killed the look of the model. I divided it into 2 models and have placed a notch on one point of the platform holder that needs to the facing the closed back of the machine fitting.
Recommend a good strong glue and allow plenty of time to set/cure
Design in Tinkercad as my license for Fusion 360 had lapsed.
I printed in both PLA and resin - Here are the details
PLA
0.15 Speed profile
20% in fill
12.79 meters of filament
Just over 3 hours to print.
RESIN
0.05
1119 layers
55ml resin used
PRUSA GREY TOUGH
4 hours 36 minutes
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!