Thingiverse
SL4 Collection
von MPoindexter
18
Downloads
13
Likes
0
Makes
This is my personal collection of 3D printed parts I have modeled around the SL4r frame created by Catalyst Machineworks. Their parts work alright, but I felt the tolerances were a bit too tight, as well as not offering exactly what I was looking for; so I modeled my own.
- The Camera mount will allow the Runcam Swift to sit lower than the standard mounts.
- VTX Antenna standoff will allow you to use the standard pigtail that comes with the Unify VTX.
- LED bar mounts a Matek 8 LED WS2812 to the rear standoffs.
- The antenna mounts will work on any frame - they just bolt to any frame screw and allow you to stick an antenna tube into it.
Added: Micro Swift mounts.
Modified the Unify VTX standoff. reduced the offset by 5mm
- The Camera mount will allow the Runcam Swift to sit lower than the standard mounts.
- VTX Antenna standoff will allow you to use the standard pigtail that comes with the Unify VTX.
- LED bar mounts a Matek 8 LED WS2812 to the rear standoffs.
- The antenna mounts will work on any frame - they just bolt to any frame screw and allow you to stick an antenna tube into it.
Added: Micro Swift mounts.
Modified the Unify VTX standoff. reduced the offset by 5mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!