Sled miniature

Small sled I modeled for a friend. It's two STL's, the full sled, and the "metal" parts. I've printed it this way, so after printing you can bend it around.

Some pointers:
The lower wooden parts (ski's?) have a bit of an angle to it. What I did, was putting the "bridge" parts with one side 1cm higher, and the other side straight onto that "ski". Then glue it.

Assembly can be tricky, make sure to have some basic tools around like pliers, sharp hobby knife and even a screwdriver came in handy pushing parts in their position. Especially with the "metal" strip going around the ski's.

Printed in the case of the photos with Makerpoint Natural Wood and Tough PLA black on an Ultimaker S5. But I'm sure this model is printable on pretty much anything, with pretty much any material.

The print in the photo was printed on 150% scale. Originally, a friend of mine needed a smaller model.

Good luck!