Sleeved cable exit

**The Part**

This part is modelled from the 'cable exit' part present on all the data mode interface products available over at https://radioarena.eu. These units are typically used for interfacing amateur radios with PCs for digital modes but sadly the cable exits are glued on to the stock cables as a rule. As the interface's mainboard is the same across their range, this printable cable exit will allow you to properly rewire them with replacement interface cables to suit a different radio.

**Possible Customisations**

By default, the printed part itself is rather small (approx 16mm x 10mm x7mm) but when resized to suit, this model may serve as a general cable exit across a range of uses. I have made the foot, stork, surround and cut-outs fully customizer-enabled. The original SCAD file is included for those who wish to tinker further. For OpenSCAD users, I have also included a debug mode that shows the primitive and intermediate geometry. This helps to explain the model's con