Thingiverse
SLI-PRO attachment for Thrustmaster Open Wheel addon
von Scotchy49
3
Downloads
1
Likes
0
Makes
This is a simple mod for the Thrustmaster Open Wheel addon to attach a Leo Bodnar SLI-PRO.
The back cover is open to allow to pass the USB/controller cables, with a seperate strain relief backplate.
You might need to drill the holes a bit bigger depending on the hole dimensions accuracy of your printer.
You will need:
- 4xM3 bolts & nuts to replace the original ones which are too short with the added width of the back plate.
- 4xM2 bolts & nuts to fix the SLI-PRO on the support.
The back cover is open to allow to pass the USB/controller cables, with a seperate strain relief backplate.
You might need to drill the holes a bit bigger depending on the hole dimensions accuracy of your printer.
You will need:
- 4xM3 bolts & nuts to replace the original ones which are too short with the added width of the back plate.
- 4xM2 bolts & nuts to fix the SLI-PRO on the support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!