Slide and Snap Box

This box allows easy printing and customization since the side panels are flat on the backside and all pieces are printed without support structure. A PDF file shows the dimensions of a blank side panel so you can easily make your own designs for the side panels. The box is held together by latches--not by friction. Both the side panels and the posts use latches. To assemble, insert two posts at a slight angle outward from the center, as shown in one of the photos. Then make them vertical and insert one side panel, pushing it down until it clicks into place. Add another post and repeat.

Similar to another box (3103914) I did, this one instead has panels that will not pull out directly perpendicular from the posts, but must be instead, slid out the end. This makes the box much stronger and eliminates the need for any kind of internal brace. Although strength is not a big issue for a box this small, it becomes important when you try to make the box bigger. (See https://www.th