Thingiverse
Sliding Bolt Latch
door Pimmz94
1
Downloads
1
Likes
0
Makes
I designed and printed this for use on a rabbit hutch door.
May have other uses.
Required a small amount of assembly, including a small bit of clean-up on the inside so that the bolt can slide easily. Was designed to be a snug fit with 0.1mm tolerance.
I glued the bolt hand to the bolt with a dab of superglue, this is optional as it was designed to pop in and remain.
Please leave feedback. Or share how this worked out for you.
May have other uses.
Required a small amount of assembly, including a small bit of clean-up on the inside so that the bolt can slide easily. Was designed to be a snug fit with 0.1mm tolerance.
I glued the bolt hand to the bolt with a dab of superglue, this is optional as it was designed to pop in and remain.
Please leave feedback. Or share how this worked out for you.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
