Thingiverse
Sliding door stopper
von hclxing
28
Downloads
22
Likes
0
Makes
This is a sliding door stopper. Part_A is the hindge, it's a inplace printed ball joint, so make sure you print it with the cylinder upward with support in the bottom hole.
The rod is a PVC pipe, measured at 20.5mm ID and 26.8 mm OD (not sure what standard pipe dimension that is)
The rod is a PVC pipe, measured at 20.5mm ID and 26.8 mm OD (not sure what standard pipe dimension that is)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!