Thingiverse
Sliding Joint Case
von AhmxdM
11
Downloads
30
Likes
0
Makes
Holds up to 3 kingsize cones.
Use support only for the leaf, and brim for better plate adhesion.
I used 2 round magnets (10x3) so the sliding part does not fall out of the case, but I assume you could still use it without magnets.
Please show me yours if you have printed it!
Use support only for the leaf, and brim for better plate adhesion.
I used 2 round magnets (10x3) so the sliding part does not fall out of the case, but I assume you could still use it without magnets.
Please show me yours if you have printed it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!