MakerWorld
Pets
Zum Modell
Sliding Panel Spider Enclosure
8
Downloads
21
Likes
2
Makes
🕷️ Sliding Panel Spider Enclosure (PLA/PETG Compatible)This is a modular spider enclosure designed with 4 sliding side panels for easy access, cleaning, and setup. Each side panel slides upward smoothly, and the tolerances have been tested to work great with PLA and PETG.PETG is recommended for best long-term performance since it handles heat and warping much better than PLA.✅ Key Features4 sliding side panels (access from any side)Smooth, reliable sliding fitment (tested PLA + PETG)Ventilation holes in the corners for airflowCountersunk hardware design so screws sit flush with the plasticRigid top + bottom frame for a strong, square buildClean, flat surfaces for a premium finished look🔩 Hardware & Materials Required8x M3 countersunk screws (20mm long)8x M3 heat-set threaded inserts (M3 × 5mm OD × 8mm long)(M3 × 5mm OD × 4mm long inserts will also work, but are less stable than the 8mm inserts)2x 4" × 4" × 1/8" acrylic sheets4x 6" × 6" × 1/8" acrylic sheets🧪
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!