Thingiverse
Sliding Puzzle Piece
von MetaKor
5
Downloads
3
Likes
0
Makes
A simple modular element for the sliding cube puzzle found [on this Reddit post](http://reddit.com/r/oddlysatisfying/comments/8ruuhg/mixing_and_matching_these_puzzles/). 3 copies of this piece are needed to create a cube.
NOTE: This is a "pure" recreation of the piece and thus does not incorporate printing tolerances. If you're going to try to print a set, make sure to sand your parts!
NOTE: This is a "pure" recreation of the piece and thus does not incorporate printing tolerances. If you're going to try to print a set, make sure to sand your parts!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
