Cults3D
€ Paid
Various
Ver Modelo
Sliding Slinger
0
Descargas
2
Likes
0
Makes
The Sliding Slinger; Notes.
Designed and built for research purposes only.
The Sliding Slinger is a repeating sling shot with magazine capable of 40+ 10mm (9.56mm) stainless steel balls.
The mechanism uses a sliding rail with the tension bands attached between two sets of “wings” and is drawn back much like a standard bow and held in that position until the ball is released with the use of the thumb trigger similar to releasing a compound bow.
The string catch mechanism is designed to capture the ball directly behind the string and is a direct adaption from the Sling Hammer design by Dondipper. (top idea mate)
The initial design was also adapted from a plywood design created by Joerg Sprave (The Slingshot Channel), so I have both to thank for those clever designs.
The length of this beast is around 600mm printed in half sections (for longitudinal strength) to fit a 300mm build plate with the front extension keyed into main section, some glue may be required for certai
Designed and built for research purposes only.
The Sliding Slinger is a repeating sling shot with magazine capable of 40+ 10mm (9.56mm) stainless steel balls.
The mechanism uses a sliding rail with the tension bands attached between two sets of “wings” and is drawn back much like a standard bow and held in that position until the ball is released with the use of the thumb trigger similar to releasing a compound bow.
The string catch mechanism is designed to capture the ball directly behind the string and is a direct adaption from the Sling Hammer design by Dondipper. (top idea mate)
The initial design was also adapted from a plywood design created by Joerg Sprave (The Slingshot Channel), so I have both to thank for those clever designs.
The length of this beast is around 600mm printed in half sections (for longitudinal strength) to fit a 300mm build plate with the front extension keyed into main section, some glue may be required for certai
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
