Sliding Vents Riser V3- Modular

If you are looking for MORE LIGHT! BETTER VENTELATION! A EASY PRINT! WITH MINUMAL FILATMENT USAGE AND PRINT TIME! I have updated my Riser and made it modular. Now you are able to have vents on all four side or none. Just depends on your needs and set-up. Helps give more light to the print chamber if you choose to add a LED strip to the upper edge. Also helps lift the glass lid up higher to prevent the PTFE Bowden tube from rubbing against it. The standard model (Vented sides, solid rear, Faceplate front is under 500g of filament in total. Only supports needed on the faceplate sections.Print profile 1:Plate 1 is for a solid rear section and the lit up front section with a face plate.Plate 2 is for the vented sections.Plate 3 is the corner sections.Plate 4 is the sliders for the vented sections.Plate 5 is the face plate that goes along with Plate 1. (This is the only object that has supports enabled for it. It needs them to support the upper edge)Plate 6 is a blank face plate so you can