slim Raspberry Pi 2/B+ case

YARC! - Yet Another Raspberry Case

there are *many* options for a raspberry pi case on thingiverse - but none quite covered all the features I was looking for... so time to design one :-)

---
**Updates**
2015-03-25 added top with groove for CSI ribbon cable and another with CSI+GPIO

---
**there are variants**:
for [M2.5 screws](/thing:716021)
completly screw-less [snap-together](/thing:717483)

---
this case tries to be:
* slender and snugly fitting around the pi
* low profile/height
* not bulky: walls are as thin as possible, but as thick as necessary to be sturdy enough
* closed, to keep dust out (the pi doesn't run that hot anyway...)
* two parts - lower part acting as coaster
* assembled with readily available parts: easy to come by M3 screws
* easy to disassemble - using the mounting holes with easy to come by M3 screws (countersunk M3x16mm) and set-in M3 nuts
* not occlude the status leds
* printable without any support structures

---