SlimeVR Case "Hexaeder"

V1 was designed to be compatible with the "Default" Components in the Docs. V2 has been redesigned to be more robust and thinner, but uses a different Battery height, smaller switch and a smaller USB-C Charge Board

For V1:

SlimeVR Case sized for a 804040 Lipo Battery (or smaller) , Wemos D1 Mini and TP4056 USB C Charging Board (Should also fit Micro-USB but not tested).

Completely tool less assembly! No Screws required, the Mount Plate is held in by friction and the Lid slides on and clips into place

The Case has a Cutout for a 5 pin JST HX Connector at the back
Compatible with most MPU 9250 and 6050. Just print the mount plate that matches the IMU you have

BNO Support Pending as I can't get any at the moment to measure.
Still working on some things but mostly done.

Pictures may be out of date
The case Dimensions are 22.4mm x 61.1 x 62.7 (HxWxL)

The whole Case can be printed as is, you might have to flip the Lid around so it is flush with the printing surface.