Thingiverse
Gadgets
Model downloaden
slimline HDD enclosure
222
Downloads
208
Likes
6
Makes
I had a few 2.5 inch drives to spare and bought a SATA to USB adapter cable
http://www.ebay.com/itm/161715024806
Dimension of SATA plug is 47x13mm
I could not find a perfect fit for an enclosure, so I designed it from scratch, making it as small and simple as possible. It can be used with or without the "back lid". The 4 side screws are used to keep the drive in place.
It prints with the SATA hole down. Supports for the bridges are included in the model, it breaks off easily after print. If you want to close the back opening, print the "lid" piece.
http://www.ebay.com/itm/161715024806
Dimension of SATA plug is 47x13mm
I could not find a perfect fit for an enclosure, so I designed it from scratch, making it as small and simple as possible. It can be used with or without the "back lid". The 4 side screws are used to keep the drive in place.
It prints with the SATA hole down. Supports for the bridges are included in the model, it breaks off easily after print. If you want to close the back opening, print the "lid" piece.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
