Thingiverse
Slimmer Simplisafe Entry Sensor Case
di seanriceaz
1
Download
0
Likes
0
Makes
This is a replacement case for a V1 SimpliSafe Entry Sensor.
I needed something that was a little less bulky to fit behind some new blinds I installed on my windows. This one is just a little wider than the original, but will lay much flatter against my wall.
To make this work, you will need to remove the electronics board and battery from the original entry sensor you want to replace.
You'll need to make one small modification to the LED leads. Bend them as seen in the pictures to get the LED to fit in the hole and reduce its distance from the board.
If you want to modify the case, here's my tinkercad file:
https://www.tinkercad.com/things/awdNFM7BThF
I needed something that was a little less bulky to fit behind some new blinds I installed on my windows. This one is just a little wider than the original, but will lay much flatter against my wall.
To make this work, you will need to remove the electronics board and battery from the original entry sensor you want to replace.
You'll need to make one small modification to the LED leads. Bend them as seen in the pictures to get the LED to fit in the hole and reduce its distance from the board.
If you want to modify the case, here's my tinkercad file:
https://www.tinkercad.com/things/awdNFM7BThF
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
