Slicer Discord
Slingbow yoke adapter – Modelo 3D imprimible de MakerWorld MakerWorld
Sport & Outdoors

Slingbow yoke adapter

3 Descargas
3 Likes
2 Makes
Ver Modelo
A simple adapter to allow arrows to be loosed from a slingshot of the tube-band type commonly found in large retail outlets. It has a 10mm hole on the top of the handle where you could presumably store extra shot. Instead you can insert this very simple device and have an arrow rest. Remember to point the guard-feather, cock-feather, or odd colored fletching (whatever you call it where you are) upward. I have also read (and confirmed) that tying a bit of paracord across the basket, pouch, leather bit, (whatever you call it where you are) to nock the arrow onto is a great help. It is not easy or intuitive to use this, and the arrow will fall off sometimes, so be careful and use shafts long enough that it wont fall down and shove through your hand. This is the easiest, and cheapest solution. Not the best. That would be a whisker biscuit on the end of rod. But then you are paying for that.
Categoría
Sport & Outdoors
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección