Thingiverse
Slip and Slide Stake Version 2
von virtualnobody
0
Downloads
0
Likes
0
Makes
I needed a replacement stake for the kids' slip and slide. A couple minutes in TinkerCAD and here we go. Enjoy.
I printed in PLA at 80% infill. For longevity maybe print in PETG, but I figured the kids will probably break it before the sun does.
I printed in PLA at 80% infill. For longevity maybe print in PETG, but I figured the kids will probably break it before the sun does.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
