Slot Car Controller Hanger

This is a design meant to be mounted to the side of a slot car track, usually on the retaining wall or side of the table, to provide a convenient and secure place to hang a controller by its trigger. This is based on the Slot Car Corner design, with minor changes to accommodate more controller types.

It can be printed without supports on most FDM printers by laying the front face down on the print bed.

Also note that in the photos of my holders on my track, I had already cut notches into the walls for my old holders (metal plates on the wall). This allowed me to have the printed holders much lower, and my track is already on the high side. The printed design is meant for the holder to be mounted higher, with at least enough room for most triggers to not hit the top of your wall or table. That's why the countersunk screw holes are only at the bottom.