Slug trap

Each 3MF file contains two parts, you need to rearrange them to lay flat.
All inclinations to not got below 30° so parts could be printed without supports (although inner side will not look smooth but who matters 😄).
The top can be secured with four ⌀2×10 mm screws.
The inner volume is supposed to be filled 50% with beer, and whole trap to be digged into the ground for 2/3 of the bottom part height.
Dimensions (D×H):
* Large slug trap: ⌀100×90 mm
* Small slug trap ⌀80×70 mm

P.S. Inspired by [this model](https://www.thingiverse.com/thing:23467) but my model has inclined walls and screw holes.