Slug Trap(UPDATED WITH LARGER MODEL!)

Slug Trap with a threaded lid UPDATE! Larger trap profile New - Larger Diameter Top of trap to bottom of lid(height for slugs to go through) Print timeFilament Used120mm 31mm (~1 ¼") 1h 59m69.9g Old - Original* DiameterTop of trap to bottom of lid(height for slugs to go through, not scaled)Print Time(*Scaled up to new size)Filament Used(*Scaled up to new size)85mm 17mm(~11/16") 2h 48m91g This new profile will save 49 minutes of print time and ~24% of filament(If the original model was scaled up to the same size as the new model). The inside wall of the trap is angled rather than 90 degrees to save on filament and reduce print time. I also added a fillet to the bottom of the rod/screw to help prevent it from breaking as easily. It will still break if too much force is applied, please be gentle. -----Original Post----- I had printed out this slug trap and it works great but the lid kept getting knocked off. This one is based off of that but I bui