Thingiverse
SM560 vertical stand
von ekirts
0
Downloads
0
Likes
0
Makes
Uses stock feet + clip thing to hold the font part in place
Use 2mm washers or standoff on side panel to use the clip thing
standoffs@108% scaling and high infill % mine was printed at i think 70% and seems to be fine.
Might merge clips to the stand
Use 2mm washers or standoff on side panel to use the clip thing
standoffs@108% scaling and high infill % mine was printed at i think 70% and seems to be fine.
Might merge clips to the stand
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!