Thingiverse
Small Brushless Motor Separator
von jc9aj
0
Downloads
0
Likes
0
Makes
I had issues separating the bell from a 2004 EMAX ECO II motor to clean out some swarf due to lack of grip.
This design is intended to be used with motors that have a 12mmx12mm M2 mounting pattern and 5mm/6mm M2 Prop mounting pattern.
It requires 2 off M4 bolts, 4 off M4 nuts, 4 off M4 washers to provide the separating force. See pictures on how these are arranged
This design is intended to be used with motors that have a 12mmx12mm M2 mounting pattern and 5mm/6mm M2 Prop mounting pattern.
It requires 2 off M4 bolts, 4 off M4 nuts, 4 off M4 washers to provide the separating force. See pictures on how these are arranged
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!