Small Dog Ramp

Made this ramp for my mom's dog Oscar. He needs a little help getting in and out of the patio door. The back of the ramp is 140mm tall. The front is 30mm tall. The model in the picture is 2x130mm wide ramps. NO glue needed. You can if you want, but if you don't, you can always take it apart. There are 60mm and 130mm width of the ramps. You can print any combination. If you print both the 60 and 130, when you slide them together, put 1-60mm and 1-130mm on one side, then you don't need to use the braces to hold everything together. The braces fit into the hexagon holes to hold everything together. You print on a flat side for strength. You can print the braces vertical, but know that that way may be less strong. I made everything so that they can slide together since I am only printing on a Prusa Mini. The sides can be used if you want. They just slot into the holes in the ramp. I added some traction tape for the no slip surface - https://www.amazon.com/4inx33ft-Traction-Non-