Thingiverse
Small dustpan V2
di Zer0s
5
Download
1
Likes
0
Makes
Work in progress because my 3D printer is down and I am not able to print it to check but I'm fairly confident that it will be fine.
My previous design was too thin and caused the edges to crack and break apart.
I have thickened the walls and made it slightly shorter while maintaining the overall width of 150mm. All these changes will improve structure rigidity.
I have printed in yellow ABS and observed some warpage at the thin wall areas holding the stick. Not a big issue to me, don't expect to see this if printed using PLA.
Clicking on my AliExpress affiliate link below will give me a small kickback
if you purchase something within 3 days. (at no extra cost to you) https://s.click.aliexpress.com/e/_DDKmhAd
My previous design was too thin and caused the edges to crack and break apart.
I have thickened the walls and made it slightly shorter while maintaining the overall width of 150mm. All these changes will improve structure rigidity.
I have printed in yellow ABS and observed some warpage at the thin wall areas holding the stick. Not a big issue to me, don't expect to see this if printed using PLA.
Clicking on my AliExpress affiliate link below will give me a small kickback
if you purchase something within 3 days. (at no extra cost to you) https://s.click.aliexpress.com/e/_DDKmhAd
Zer0s pubblica anche su
111 modelli aggiuntivi su altre 2 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
