Thingiverse
Small flat automotive interior light
door wd73_
42
Downloads
25
Likes
0
Makes
I made this ceiling light for my camper van.
It's a minimalistic design and mounts in a 100mm hole.
With 3 mounting hooks, it can be secured turning the (M5) screws 90 degrees.
Hooks are made for ceiling panels of 5mm thickness.
You have to print:
- 1 housing
- 1 plate
- 3 mounting hooks
Glue the houding to the case using acetone if printed with ABS of glue otherwise.
The switch used is a regular on/off rocker switch from ebay (search for "On/Off Snap boat Rocker Switch")
The light itself is a small 12V halogen lamp i had laying around
It's a minimalistic design and mounts in a 100mm hole.
With 3 mounting hooks, it can be secured turning the (M5) screws 90 degrees.
Hooks are made for ceiling panels of 5mm thickness.
You have to print:
- 1 housing
- 1 plate
- 3 mounting hooks
Glue the houding to the case using acetone if printed with ABS of glue otherwise.
The switch used is a regular on/off rocker switch from ebay (search for "On/Off Snap boat Rocker Switch")
The light itself is a small 12V halogen lamp i had laying around
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
