Thingiverse
Small Floating Bookshelf
door SidCollinsIV
109
Downloads
122
Likes
0
Makes
This small floating bookshelf is my solution to the all too common scenario of not knowing where my journal is or the book I am currently reading just cluttering up the desk. So, with a problem, an idea, and a few minutes in Fusion 360. Voila!
The shelf is mounted to the wall using three 3 lb command strips. So it will not hold very much weight, but then again, I only designed it for a couple of books. Any larger and I would not have had room on the print bed.
At 0.3 mm, this took about 8 hours to print on my Monoprice MakerSelect. Of course, this will differ with your settings. As far as the orientation goes, I recommend printing with the open rectangular face DOWN on the print bed. This makes it possible to print without supports.
The shelf is mounted to the wall using three 3 lb command strips. So it will not hold very much weight, but then again, I only designed it for a couple of books. Any larger and I would not have had room on the print bed.
At 0.3 mm, this took about 8 hours to print on my Monoprice MakerSelect. Of course, this will differ with your settings. As far as the orientation goes, I recommend printing with the open rectangular face DOWN on the print bed. This makes it possible to print without supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
