small footprint joycon grip controller stand

This is a vertical stand for the Nintendo Switch joycons and joycon grip that comes in the box with the Nintendo switch.

I decided to remix the version created by twlum (https://www.thingiverse.com/thing:3897267 ) to give it a smaller footprint, straighten the walls, and to smooth out the channel. I also removed the logo. I used a combination of Fusion 360, Meshmixer, and Blender.

This holder printed in about 3 hours at 0.28 layer height at 60mm/s. This was my third time printing it and got this one to work well without requiring any sanding. I did knock off a couple tiny bumps with an Exacto knife near the left joycon controller walls which took only a few seconds in order to make the controller fit very well.

Enjoy!