Thingiverse
Small Items Drawer (With label inserts)
door PaulTheSimon
137
Downloads
95
Likes
2
Makes
Update (2018-06-16) - Design improvements for better grabbing, and notches that keep the drawers from falling out.
This is a little drawer for putting your screws, electronic bits, or various other small objects into.
You can insert labels into slits on the drawers and they will be visible in the circular "windows".
To print this at 100% scale, you need a print volume of at least 120.8 x 120.8 x 60 millimeters.
The drawers are approximately 30 millimeters wide/tall, and 60 millimeters long.
The paper label inserts should be approximately 22 millimeters wide and 20 millimeters tall.
The tolerance for the sliding mechanism is 0.4 millimeters. While this is quite generous, be sure that your printer is capable of it before spending several hours printing this.
Leave a message if you have any suggestions, complaints or comments!
This is a little drawer for putting your screws, electronic bits, or various other small objects into.
You can insert labels into slits on the drawers and they will be visible in the circular "windows".
To print this at 100% scale, you need a print volume of at least 120.8 x 120.8 x 60 millimeters.
The drawers are approximately 30 millimeters wide/tall, and 60 millimeters long.
The paper label inserts should be approximately 22 millimeters wide and 20 millimeters tall.
The tolerance for the sliding mechanism is 0.4 millimeters. While this is quite generous, be sure that your printer is capable of it before spending several hours printing this.
Leave a message if you have any suggestions, complaints or comments!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
