Small night light - touch sensor

Hi,Here is a little something to help you find your way around at night without hurting your toes on the bed, knocking things over or disturbing the CAT, a small night light that you only need to touch to turn ON and OFF.The model is 60mm in diameter by 60mm in hight, printed in PETG, standard 0.2 layer, 15% infill.The build uses 2 x 2032 batteries, a TTP223 touch sensor and a piece of wire for connections (you would also need a soldering wire). Building steps:put the LEDs pins through the 2 small holes and glue it in place! See the pics for LED orientation(polarity)!!!bend the legs twice at 90 degrees (see pics), after cut the pins around 6-7 mm in hightplace the sensor with the “touch” cercle facing up and insert the LEDs pins in the left 2 holes(check polarity). The is a rectangle outlined in the print for sensor placement, you need to be inside the rectangle.cut 2 pieces of wire to solder for positive and negative battery connectionsadjust the length of wire (see pics)GOOD LUCK & E