MakerWorld
Organizers
Model downloaden
Small part drawer compartments
118
Downloads
40
Likes
27
Makes
Print in place organizer drawer. Design inspired/copied from Slant3D video(Linked below).36 total compartments.each tub is 32mmx32mmx90mm(90mm at the top, 50mm at the bottom)No supports neededEach compartment prints with a small tab at the bottom to keep them in place when pulled off the print plate.just pull out the easily break the tab.print takes about 9 hours in sport mode without any defectsincluded step. file of individual compartment for replacements or editing
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!