MakerWorld
Electronics
Zum Modell
Small Ploopy Adept trackball case with BTUs
40
Downloads
29
Likes
12
Makes
A small Ploopy Adept case with BTU bearings. I wanted something smaller and lower to use between the two parts of my split keyboard. So I created this case for the Ploopy Adept, which is pretty small and low. It is designed for a 1.5inch (38.1mm) trackball and BTUs.For more info, BoM and assembly instructions please check https://github.com/fabriciobastian/ploopy-adept-small-btu There are 3 print plates. The print plate 1 (buttons) is best printed using PETG HF, the other plates can be print using PLA. I recommend using 0.12mm for plates 1 and 2 and then print plate 3 (cover and keycaps) with the best quality possible for a better finish. I have added 3 different print profiles for these recommendations. Use these profiles according to their names, to print each of the plates.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!