Small Rain Barrel

I blew up RobagoN's Gloomhaven barrel 200% (too big), hollowed it out and added a pipe connector to the bottom.

I had a lot of adhesion problems with a right angle pipe, building it into a cube seemed to be a good way to handle it.

I printed the barrel connector side down with some supports to hold it up. It might work upside down without supports, haven't tried yet. Nothing is oriented for best printing right now.

The pipes have an inner diameter of 6mm and outer of 8mm. The female end of the connectors is 8mm inner and 10mm outer. The male end is 3mm long, with a 5% taper. I may make it shorter, 2mm taper and the female end 3mm so there's a full mm of contact.

To do: pipes to connect to, additional cisterns