Thingiverse
Small sliding bolt
by Sagittario
237
Downloads
208
Likes
1
Makes
This is a small sliding cupboard/door bolt.
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run backwards. (be careful doing this,
The sliding bar is deliberately flat on one side so it can be printed horizontally.
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run backwards. (be careful doing this,
The sliding bar is deliberately flat on one side so it can be printed horizontally.
Sagittario also publishes on
76 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
