Thingiverse
Small Spool (10cm) v2
von gladson76
0
Downloads
0
Likes
0
Makes
A small spool designed in Tinkercad.
This is a modification of the first one here..
https://www.thingiverse.com/thing:6654122
Outer diameter is 10cm and the inner diameter is 4cm.. should fit all printers..
The small clips for the filament are for 1.75mm filaments.. use an exacto knife or screwdriver to widen it if needed..
Print twice and attach together.. should hold fine.. add a drop of quick glue if it doesn't..
This is a modification of the first one here..
https://www.thingiverse.com/thing:6654122
Outer diameter is 10cm and the inner diameter is 4cm.. should fit all printers..
The small clips for the filament are for 1.75mm filaments.. use an exacto knife or screwdriver to widen it if needed..
Print twice and attach together.. should hold fine.. add a drop of quick glue if it doesn't..
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
