Small Table - MUST READ.

What more can I say other than it's a table ? These instructions are important : Well, it's based on a mexican table I own initially and then I have added my own top design. There are 3 sections to this, that require multiple prints and modification, depending on YOUR setup. Size 245mm x 245mm bed required minimum. If you have a bigger printer, you can scale up everything to suit. talking with another modeller on here about tolerances, (shout out to darren) we came to the conclusion that each printer setup will give off different resutls so I p it is best to let YOU do the tolerances. You may need to work on the legs but the idea is to prevent that, just by using scale. The same for the rods that join the two halves of the table together. GLUE is possibly required. Friction fit is possible but glue will help finish the job. When you print the rods, use 100% infill. Print 2x Table TOP - No scale required. Print 6x Table ROD - Scale this by 1% down to 99% - Print ONE and Test fit. Half in each side of the table, naturally, fit all 6 to one side first. Add glue. IF you feel they are too tight or too loose, adjust scale accordingly. Print 4x Table LEG - Scale this by 1% up to 101% OR the same scale you use for the above RODS.