Small Tarantula Pro Guide

Just a filament guide. Its much smaller and less ugly than the rest ive seen while searching, just use a small amount of the second ptfe tube that came with the printer or all of it if you dont want to cut it i guess, it might work without one too like the other guides (probably not)
Its a tight fit on the extruder, change the big hole if you cant insert the ptfe tube (mine was a bit tight but thats good cause i didnt want to use any glue and it didnt effect the filament flow! (oh and put you finger bellow the arm when pushing this in because u might brake it, or sand it to make it fit easier)