Small Vise with quick adjustment

This version leans heavily on the "Small Vise V2 by Bastien" version. Added is the possibility of adjusting the screw via a quick adjustment. This is very convenient, because the annoying turning of the screw at larger distance changes is eliminated.

The quick adjuster is a small additional block that is inserted into the main body of the vise.
The following steps must be followed:

1.) Print the two 3D parts ("quick adjustment main.stl" & "quick adjustment 02.stl")
Note: "quick adjustment main.stl" was printed lying on the large back side. A (Tree) support was used on the lever and support blockers were added to the holes (optional) (Cura Slicer).
2.) Cut the M10 nut in half with a hacksaw
3.) Cut off a part of a ballpoint pen spring
4.) Assemble the parts

In total the following parts are needed:
- M10 screw approx. 120mm
- half M10 nut (see above)
- ballpoint pen spring

Also see: https://youtu.be/xCnPjfD_GQs