Thingiverse
Small watering can
door FuseCraft
1
Downloads
2
Likes
0
Makes
It is a simple small watering can that is only need a little bit of support.
The watering can is printed upside down in two parts that snap fits together.
In this way you have to use silicon or some type of waterproof glue but it doesn't need that much support and easier to print.
If you print it at least with a line width of 0.7mm then it only needs just a little bit of support for the handle.
I haven't tried it without support but it may works so please let me know the results if you going to try this.
For the Z seams if you set smart hiding in Cura (or similar feature in other slicers) it shouldn't leak.
Also if you don't set the speed too high then the layers melt together better and ideally you won't have leaks.
The watering can is printed upside down in two parts that snap fits together.
In this way you have to use silicon or some type of waterproof glue but it doesn't need that much support and easier to print.
If you print it at least with a line width of 0.7mm then it only needs just a little bit of support for the handle.
I haven't tried it without support but it may works so please let me know the results if you going to try this.
For the Z seams if you set smart hiding in Cura (or similar feature in other slicers) it shouldn't leak.
Also if you don't set the speed too high then the layers melt together better and ideally you won't have leaks.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
