Thingiverse
Smaller Filament Spool
von damienholloway
7
Downloads
1
Likes
0
Makes
Spool with customized label for shorter cuts or lengths that you acquired without a spool.
You can adjust the width of the spool too!
The mesh/hexagon design uses less filament too!
Prints without supports and does not need screws or any hardware to assemble.
By default it has dimensions
- Outer Diameter: 160mm (80mm radius)
- Inner Diameter: 20mm (10mm radius) (ie centre hole)
You can adjust the width of the spool too!
The mesh/hexagon design uses less filament too!
Prints without supports and does not need screws or any hardware to assemble.
By default it has dimensions
- Outer Diameter: 160mm (80mm radius)
- Inner Diameter: 20mm (10mm radius) (ie centre hole)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!