Thingiverse
SMART Card Box
von AndersE
6
Downloads
11
Likes
0
Makes
This is a box for Retroleum´s SMART Card SD adapter for Sinclair Spectrum.
I printed in Clear PLA, 0.3mm layer with supports.
There are no screwholes in the adapter so i hotglued it in place, just make sure the buttons are aligned..
The lid is snapfit, so no screws. (need well calibrated printer).
I printed in Clear PLA, 0.3mm layer with supports.
There are no screwholes in the adapter so i hotglued it in place, just make sure the buttons are aligned..
The lid is snapfit, so no screws. (need well calibrated printer).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!