Smartbox Case Latch

Replacement latch for a Pelican style case used by SmartBox for their key programming system.
I believe the brand is actually HUL but it has no identifying marks.
Seems they make a lot of drone carrier boxes as well so I hope others can make use of it.

Drive the metal pins out with a pin punch, awl, skinny screwdriver, whatever then drive the second shorter pin out the same way. I find a slightly open bench vise to be a perfect place to do this.
Reverse the process with the new part. The vise is a great way to drive the smaller pin back in again. I had no problems driving the pin into the printed part.
Part is oriented for maximum strength supports will be needed.
Mine is an okay fit but if I were to reprint them I'd probably reduce the length by a milimeter or two to make it a bit tighter.
Only post-processing was removing the infill.