SmartPaw | Gyroid Interactive Cat Feeder

SmartPaw | Gyroid Cat Feeder (.3mf Project File)Dry food dispenser for cats, designed completely inside Bambu Studio using primitive shapes. Features an open Gyroid outer structure. Can also be repurposed as a kitchen sponge holder/drainer! 🛠️ Mechanism & Assembly This model uses a 3D printed TPU sponge instead of traditional springs:TPU Sponge: 0 wall loops, 0 top layers, 0 bottom layers, and Gyroid infill for maximum softness.Placement: Position the printed TPU sponge as close as possible to the notch in the base for correct button compression.Alternative: If you do not have TPU, you can use a real kitchen sponge of the appropriate size and placed in the same position. Cat-Proof Lock: Rotate the top lid by 45 degrees after putting it on to lock it securely so your cat cannot open it. Assembly Note: For best stability, it is highly recommended to tape Part Number 1 and Part Number 3 together. 🐈 Safety & CleaningFilament: Recommended to print food-contact parts using Bambu Lab PLA Pure.Cleaning:Rinse with a strong stream of warm water to clean the open gyroid walls.Soak in warm water with dish soap for 10 minutes.Spray with 70% Isopropyl Alcohol (IPA) to sanitize layer gaps.Dry completely with a fan or cold air hair dryer before refilling. - IMPORTANT SPEED WARNING: DO NOT print this model with a speed rate HIGHER THAN 100%! Do NOT use Sport or Ludicrous mode. High speed will ruin the mechanism.