Slicer Discord
Smartphone stand flat angle, minimalistic & smart – Modelo 3D imprimible de MakerWorld MakerWorld
Gadgets

Smartphone stand flat angle, minimalistic & smart

0 Descargas
0 Likes
0 Makes
Ver Modelo
It's a simple model and perhaps not perfect. But I wanted to publish it because I like the design and it works well in many respects. The angle of the smartphone holder is considerably flatter than 45 degrees. This allows you to view your smartphone from a higher position and operate it without it slipping and in a stable manner: when cooking, for example, a smartphone lying flat on the counter cannot be operated without slipping, can get dirty and is not at a good viewing angle because the ceiling lamp reflects. However, most other smartphone stands are too steep, usually at 45 degrees or more, to provide a perfect viewing angle when standing. The support used here is difficult to remove, but this can of course be made a little easier with other supports. I am looking forward to receiving corrections or suggestions.
Categoría
Gadgets
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
impresión grande
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 2/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Cama mín.
200 mm (Grande)
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

1 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección