Thingiverse
Smartphone stand
door teru84
38
Downloads
60
Likes
0
Makes
Simple smartphone stand, with back hole that allows to pass the charging cable.
Printing:
Supports and plate adhesion brim is necessary.
Rotate the model sideway, to produce a better print and to reduce the filament used as support.
Set layer height to 0.16 to appreciate the chamfers. Otherwise 0.2 is fine too.
Printing:
Supports and plate adhesion brim is necessary.
Rotate the model sideway, to produce a better print and to reduce the filament used as support.
Set layer height to 0.16 to appreciate the chamfers. Otherwise 0.2 is fine too.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
